+- Discovery Gaming Community (https://discoverygc.com/forums)
+-- Forum: Discovery Development (https://discoverygc.com/forums/forumdisplay.php?fid=7)
+--- Forum: Discovery Mod General Discussion (https://discoverygc.com/forums/forumdisplay.php?fid=37)
+--- Thread: Quick Question (/showthread.php?tid=20120)
Quick Question - Shaka - 05-05-2009
I'm learning to use metasequoia, and I was wondering if there is a mirror tool. As in, could I model the left side of something, and then mirror it to the other side. If there is such a tool, where would I access it?
thanks
Shaka
Quick Question - Boss - 05-05-2009
There is. Highlight the desired points/polys, and it's under the Selection menu.
For some reason, it doesn't like mirroring chunks, preferring to do the whole model instead. (this irks me)
Quick Question - tansytansey - 05-05-2009
Also, if you can't see the "Mirror" Function where Boss described it, make sure you are not in basic mode. Go to 'file' and make sure 'basic mode' is unchecked.
Quick Question - Shaka - 05-06-2009
' Wrote:Also, if you can't see the "Mirror" Function where Boss described it, make sure you are not in basic mode. Go to 'file' and make sure 'basic mode' is unchecked.
Woah! Where did all of those buttons appear from:D
Thanks a lot.
Quick Question - darthbeck - 05-06-2009
one word of advice. make sure that the whole model is centered before mirroring. other wise weird things hapon.