little update to the aquillon carrier

[Dab]

As I mentioned on the dev forum, a model update for the Aquilon was sorely needed, this is definitely a good step up.

Two suggestions; The rear is a bit too skinny and long. I'd split the tail in two, making it look less like a stinger. Each half would go over its respective engine block, and either go straight back with the outside edge curving in while the inner edge is straight, or the entire thing curves back inwards, almost reconnected at the back.

The other suggestion is about the side wings. The current ones bend at the tip and make it look like a beetle from the front and back. I'd decrease the angle of the bend to the point where it just slightly bends downward, then also bend it backwards, so it points to the side and back, instead of downwards.

---