Corsair signatures

[ProfGiggles]

I would drop the bevel on all of them. Looks corny. Good start but, I would like to offer some advice.

I suppose those signatures with the jagged edges are supposed to be torn, right? Us a small brush, with more lines on it. Go through with that and just nip away at the edges. Take another brush smaller than that one and pick away at those areas again. Once finished use the burn tool, and burn around the edges. Would give you a much nicer effect.

On the third one, I would suggest making the outline using the polygonal lasso tool. Select your starting area on your image and hold shift, it will conform any angle you make to 90 and 45 degrees. So it looks more uniform.

Here is a quick mock up I did, showing both examples I mentioned.

Thanks for the advice. That will give me something new to experiment with.:)

---